I was able to size the bezel using the small piece of smoked glass as a template and then cutting it to size using a straight edge and razor. I was also able to round the corners of the bezel to fit into the rabbet in the tabletop with a pair of scissors. I think it came out pretty good.
I also cut the t-molding to fit around the edges of the tabletop and placed the bigger tempered piece of glass on top. Eventually, the glass will be held to the top with some glass clips that screw into the underside of the table and extend out over the top to hold the glass in place.
Here are the latest pictures:
No comments:
Post a Comment